How to install WATER temperature gauge & How to install OIL pressure gauge in Small Block Chevy 350
In this video, Ill show you how to install water temperature gauges, and how to install oil pressure gauges in your classic American muscle car if you don’t have them already. I bought a really CHEAP unit, but when I do this again I’ll go for a better quality unit for sure. But the install goes about the same, attached the aux gauge faceplate to the underside of your dash, then run the line from the oil pressure gauge to the oil pressure port on your chevy small box 350 motor (next to the distributor), then run the plastic line from the water temperature gauge to an open port on your block or in my case the intake. I didn’t hook up the volt gauge yet, but will down the road. I don’t recommend the kit I bought over at HF, I would go for a MOON unit or etc if I was to do this again. The time it took to install the water temperature gauge and to install the oil pressure gauge in my 1967 Pontiac Firebird with SBC 350 was about an hour or so. But at least now I can see how hot the motor is running and if I am getting oil pressure. Thanks for watching guys!